Load the standard DR-1X script for alsamixer. I would adjust it using an ID-5100 since the RX is so picky. This was the most difficult part of the process but these settings should get you on the right path. If you have any issues Mike Morneau provides a good step by step dstarrepeaterconfig guide, I found it easier to use command line approach. Setup the UDRC™ for using the mini DIN-6 port: Setup the UDRC™įollow the Wiki for converted analog repeaters. Set the operation mode to duplex, change the bandwidth to narrowband and finally set your frequency and hang-times as required. Do not set any encode/decode tones (Note: it may be possible to use tones to have dual mode repeater - K7VE), remove the courtesy tone, remove the CW id, do not use multi table, and do not scan del/add. Remove all functions for the 6 programmable pins on the DB25, you won't need them for the UDRC. com/kenwood/pdfs/tkr-850-svc- man-revised.pdf Programming the TKR-750/850 Repeater If you require further information use the UDRC™ II pinout provided on the NW Digital Radio site and use the TKR-850 manual page 52 (the DB25 pinouts are the same on both the TKR-750 and TKR-850).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |